AEG 7023 TK ELECTRONIC Notice D'utilisation page 81

All manuals and user guides at all-guides.com
Heat exchanger clogged.
Max. loading exceeded.
Covered ventilation grill.
Residue inside the drum.
High water hardness.
Loading door
Filters not locked in place.
does not close
Err
( Error ) on
Attempt to change parameters after
5)
start of the programme.
the LCD.
Programme selector in OFF position.
No drum light
Defective light bulb.
Abnormally
Time to end is calculated on the basis
elapsing time
of: type, volume and dampness of laun-
5)
dry.
on the LCD
Programme
Full water reservoir.
inactive
Drying cycle Small laundry volume./Too dry laundry
to short for selected programme.
Fluff filters clogged.
To high loading volume.
Drying cycle
Laundry insufficiently spun.
6)
to long
Particularly high room temperature -
no machine fault.
1) In case of error message on the LCD (e.g.
programme. Press the START PAUSE button. Does not work? - inform local service and quote the error code.
2) follow program recommendation - see Programme overview chapter
3) see Care and cleaning chapter
4) see Machine settings chapter
5) only dryers with the LCD
6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
Clean heat exchanger.
Respect max. loading volume.
Uncover ventilation grill in base area.
Clean the drum inside.
Set suitable water hardness
Install fine filter and/or snap course fil-
ter into place.
Turn the dryer off and on. Set requested
parameters.
Turn it to DRUM LIGHT (if available) or
to any programme.
Replace light bulb (see next section).
Automatic process; this is not a ma-
chine fault.
Empty water reservoir
PAUSE button.
Select time programme or higher drying
level (e.g. EXTRA DRY).
Clean fluff filters.
Respect max. loading volume.
Spun adequately the laundry.
Lower the room temperature if possible.
E51
- only dryers with the LCD): Switch the dryer off and on. Set
What to do if ... 81
3)
4)
.
3)
, press START