Panasonic BT-LH2600W Guide D'installation page 8

4. Prepare the LCD monitor
Attach the insulation spacers to the LCD monitor.
Place the LCD monitor face down on a
blanket or other soft cloth that is clean
and free of debris, and follow the
procedure below.
Use the included hexagon wrench to
attach the allen head countersunk screw,
dished toothed washer, and insulation
spacer (four each) to the tapped holes for
fixing insulation spacers, as shown in the
right diagram.
5. Attach the LCD monitor to the wall mount adaptor and connect wiring
Loosen the left and right red screws for open/close
1
fastening (one each on the left and right sides).
1
Hook the insulation spacer on the top of the LCD
２
monitor over the notches on the adaptor, and allow
the LCD monitor to hang from the adaptor.
Pull the LCD monitor forward, as shown in the right
３
diagram, and then connect the wiring.
After wiring is finished, slightly raise the LCD monitor
４
and insert the lower insulation spacers into the lower
part of the wall mount adaptor.
Lower the LCD monitor into place.
５
Note
• If the LCD monitor is raised too mush, there is a risk that
it may become unhooked from the top of the adaptor.
6. Secure the LCD monitor
Insert the supplied unit fixing screws into the indicated holes at the left and right sides of the wall mount adaptor.
1
Firmly fasten the red screws for open/close fastening
２
holes on the sides of the wall mount adaptor.
After the installation, check again to make sure the necessary parts are firmly attached.
３
Note
• Be sure to firmly tighten (0.9 – 1.1 N·m) the unit fixing
screws on the left and right sides to keep the LCD
monitor from falling off the wall mount adaptor.
• To readjust the angle, remove the unit fixing screws,
adjust the angle, and then fasten the unit fixing
screws again.
8
Tapped holes for
insulation spacers
Allen head countersunk screw
Dished toothed washer
Insulation spacer
Top insulation
spacer
1
②
Top notch
③
(one each for the left and right, 2.7 – 3.3 N·m) in the indicated
1
Unit fixing screw
Red screws
Lower hole
for open/close
fastening
○
４
○
５
Lower insulation
spacer
Red screws for
1
open/close fastening
Wall mount adaptor
Position for inserting
unit fixing screw