Switching Modes; Setting The Temperature; Setting The Timer - HASE Luno Gas Mode D'emploi

TIMER: Timer mode
During heating periods P1 and P2, the temperature is controlled in the
same manner as in automatic mode.
If the timer switches to  (heating cycle off), the actuating motor sets
the valve to standby (permanent pilot) and the temperature control is
deactivated, which minimises battery consumption.
In order to maintain automatic temperature control in the  mode
as well, the  temperature must be set to 4°C or higher.
4.5

Switching Modes

Pressing the SET button cycles through the various modes in the following sequence:
MAN   TEMP   TEMP  TIMER and back to MAN
From any mode, press ▲ or ▼ to return immediately to manual mode.
4.6

Setting the Temperature

Press the SET button until the  TEMP or  TEMP modes are displayed.
Hold the SET button until the temperature display starts fl ashing. Press ▲ or ▼ to set the
desired temperature.
72
All manuals and user guides at all-guides.com
4.7

Setting the Timer

Press the SET button until the TIMER mode is displayed. Hold the SET button until the timer
display starts fl ashing. Set the start time for heating period 1 (P1) by pressing ▲ to set the
hour and ▼ to set the minutes.
Press the SET button again to set the end time for heating period 1 (P1).
Pressing the SET button once again lets you set the times for heating period 2 (P2-P2).
If you only want to program one heating period, simply enter identical times for P1/P1
and P2/P2.
Once all times are set, press OFF to store the values.
4.8 Igniting the Stove
Prior to starting the ignition process, the left con-
trol knob (a) must be turned to the "OFF" positi-
on and the right control knob (b) must be turned
to the "ON" position. Furthermore, the ON/OFF
switch must be activated.
Simultaneously press the OFF and ▲ buttons of
the receiver for ignition.
An acoustic signal indicates that the start sequence has begun.
The electronic system then checks that the main gas is fl owing and ignites the main burner;
this may take up to 20 seconds.
You may need to repeat the ignition sequence several times.
Please note:
Once the pilot fl ame ignites, the motor automatically sets the main burner to maximum
fl ame height.
Using the remote control, you now can operate the stove in one of the modes described
above.
c
a
b