Cup-Warmer; Hot Water Dispensing; Steam Dispensing - La Cimbali M39 Class GT Utilisation Et Installation

23
CAUTION: do not put any cloth on the cup-
warmer.
The machines have a cup warmer tray (23) for stocking and
pre-heating the cups.
The dispensing of hot water is controlled by the economizer
which permits mixing hot water from the boiler with fresh cold
water from the mains and controls its temperature.
With this system, water quality is improved and assures the
best results for the operator.
After having placed an appropriate container under the
dispenser, proceed in either of the following two ways:
- Press the DOSING BUTTON (12) that has the appropriate
memorization.
- For CONTINUOUS dispensing, press the STOP push button
(35).
Dispensing, whether for dosed servings or in the continuous
dispensing mode, can be interrupted at any time by pressing
the START-STOP push button.
NOTE:
- When using any of the dosing buttons, dispensing can be
interrupted by pressing the STOP button; the memorized
data will not be affected.
- The adjustment of the economizer for regulating the deli-
vered water temperature is made by the installing service
technician.
The machine has a knob (20) control that permits the gradual
delivery of steam, which is required for making emulsified
beverages.
When heating a beverage, insert the steam spout (9) into the
beverage and then turn the knob (20).
When finished, turn off the steam.
Note: At the conclusion of each steam dispensing phase,
clean the inside of the steam nozzle as follows:
Turn the nozzle towards the cup tray and carefully
activate steam dispensing at least once.

11. Cup-Warmer

22

12. Hot water dispensing

13. Steam dispensing

Only place cups and glasses used with the coffee machine on
the cup tray. No other objects must be placed on the tray.
Thoroughly drain the cups before placing them on the tray.
To activate the resistance of the cup warmer tray (23) press
button (22); to change the cup-warmer power, press the (22)
key a number of times.
- All LEDS on = full power
- All LEDS off = OFF
To desactivated the heating of tray (23) press more times the
key (22) until all the leds are off.
Note. The heating of the cup warmer tray (23) is deactivated
during the automatic switch off phase.
The condition in effect at the time when the machine was
switched off will be restored the next time the machine auto-
matically switches on.
12
40 EN
English
35
12
20
9
English