AEG DI 8610 Notice D'utilisation page 69

All manuals and user guides at all-guides.com
• For extractor versions (13A), connect the other end of the exhaust
pipe to the flue.
For filter versions (13F), fit deflector F to the support and secure it to
the bracket supplied using 4 screws, then connect the exhaust pipe
to the connection ring located on the deflector.
• Fit the nuts with fixing hooks (14) supplied inside the top and bottom
sections of the flues at the rectangular slots. A total of 14 nuts must
be fitted.
• Join the two top sections of the flue to cover the support (15) so that
one of the slots on the sections is situated on the same side of the
control panel and the other on the opposite side. Screw the two
sections together with 8 screws and springs (4 each side- see the
plan diagram for joining the two sections - springs must be fixed
horizontally).
• Fix the top flue assembly to the support, near the ceiling, with two
screws (16 - one each side).
• Carry out electrical connection of control panel and bulbs (17).
• Join the two bottom sections of the flue covering the support (18)
using 6 screws and springs (3 each side, see the plan diagram for
joining the two sections - springs must be fixed horizontally).
• Insert the bottom section of the flue in its seat so that it completely
covers the motor compartment and electrical connection box, then
ensure it from inside the hood using two screws (19).
• Apply the 2 tabs (20 - supplied) to cover the fixing points of the
bottom flue (CAUTION! THE BOTTOM FLUE TABS ARE THE
NARROWER AND SHALLOWER ONES).
The wider and deeper tabs are those used for the top flue, and must
be cut to size.
If necessary, slightly expand the tabs to ensure their adherence to
the flue.
• Turn the mains power on again at the central electrical panel and
check for correct hood operation.
69