Measuring Functions - Bosch DLE 70 Professional Notice Originale

22 | English
Continuous Laser Beam
If required, the measuring tool can also be
switched to the continuous laser beam mode. For
this, push the button for continuous laser beam
13. "LASER" lights up continuously in the display.
Do not point the laser beam at persons or
animals and do not look into the laser beam
yourself, not even from a large distance.
In this setting, the laser beam also remains
switched on between measurements; for meas-
uring, it is only required to press the measuring
button 10 once.
To switch off the continuous laser beam, press
button 13 again or switch the measuring tool
off. When switching on again, the measuring
tool is in the standard operation mode and the
laser beam appears only after pushing the meas-
uring button 10.

Measuring Functions

Length Measurement
For length measurements, press button 5 until
the indicator for length measurement
in the display.
Press the measuring but-
ton 10 once for sighting
and once more to take the
measurement.
The measured value is indi-
cated at the bottom in the
display.
Area Measurement
For area/surface measurements, press button 5
until the indicator for area measurement
appears in the display.
Afterwards, measure the length and the width,
one after another, in the same manner as a
length measurement. The laser beam remains
switched on between both measurements.
After taking the second
measurement, the area/
surface is automatically
calculated and displayed.
The last individual meas-
ured value is indicated at
the bottom in the display, while the final result
is shown at the top.
1 609 929 R53 | (23.7.08)
All manuals and user guides at all-guides.com
Volume Measurement
For volume measurements, press button 5 until
the indicator for volume measurement
appears in the display.
Afterwards, measure the length, width and the
height, one after another, in the same manner as
for a length measurement. The laser beam remains
switched on between all three measurements.
Values above 99999 m
"Error" and " –––– " appear on the display. Di-
vide the volume to be measured into individual
measurements; their values can then be calcu-
lated separately and then summarized.
Minimum Measurement (see figure F)
The minimum measurement is used to deter-
appears
mine the shortest distance from a fixed refer-
ence point. It is used, as an example, for deter-
mining plumb lines or horizontal partitions.
For minimum measurements, press button 4
until "MIN" appears in the display.
To start the measurement, briefly press the
measuring button 10.
Move the laser back and forth over the request-
ed target (e.g., the room ceiling for determining
the plumb line) in such a manner that the refer-
ence point of the measurement (e.g., the tip of
the positioning pin 15) always remains at the
same location.
the display. It is always overwritten, when the
current length measurement value is lower than
the present minimal value.
To end the minimum measurement, briefly press
the measuring button 10. Pressing the measur-
ing button again starts a new measurement.
After taking the third meas-
urement, the volume is au-
tomatically calculated and
displayed. The last individ-
ual measured value is indi-
cated at the bottom in the
display, while the final re-
sult is shown at the top.
3
cannot be indicated;
During the measurement,
the current length meas-
urement value is indicated
at the bottom of the dis-
play. The minimum value is
indicated at the top right in
Bosch Power Tools