Canarm BPT12H Mode D'emploi

BATHROOM
EXHAUST FANS
OPERATION INSTRUCTIONS AND PARTS MANUAL
READ AND SAVE THESE INSTRUCTIONS
GENERAL SAFETY
WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1. This ventilation fan is approved for use over a bathtub or shower when installed in a GFCI protected circuit. Do not use unapproved
fans over a bathtub or shower that does not include a GFCI protected circuit.
2. Installation work must be carried out by a qualified person(s) in accordance with all local and safety codes including the rules for
fire-rated construction.
3. To reduce the risk of fire, always vent fans to the exterior and in compliance with local codes. Do not vent exhaust air into spaces
within walls, ceilings, attics, crawl spaces, or garages.
4. Install ductwork in a straight line with minimal bends.
5. Use 120 V, 60 Hz for the electrical supply and properly ground the unit. Follow all local safety and electrical codes.
6. Do not use this fan with any solid state control device; such as a dimmer switch. Solid-state controls may cause harmonic distortion,
which can cause a motor humming noise.
7. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.
8. Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from
being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device,
such as a tag, to the service panel.
9. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent
back drafting. Follow the heating equipment manufacturer's guideline and safety standards such as those published by the National Fire
Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the
local code authorities.
10. Not to be installed in a ceiling thermally insulated to a value greater than R40. (This is required for installation in Canada only).
PRE-INSTALLATION
When installing the ventilation fan in a new construction site, install
the main body of the fan and duct work during the rough‑in
construction of the building. The grill should be installed after the
finished ceiling is in place.
When installing in existing construction, use the dimensions shown
below to determine the required hole size for the ceiling.
Grill edges should overlap finished ceiling.
NOTE: If installing in existing construction, you must have access
to space above and below the installation location.
If you are replacing an existing fan, ensure that the new grill will
adequately cover the existing opening.
Do not install ventilation fan in areas where the duct work will require
configurations shown right.
DIMENSIONS
PRODUCT SPECIFICATIONS
MODEL DUCT DIAMETER
BPT12-13H
4"
BPT12-13H-M-10_19_17
BPT12-13H
BPT12-13H
(For bathroom size up to 75 ft 2 )
9.4"
9.4
VOLTAGE Hz POWER CONSUMPTION
120 60
Turning angle too sharp
Too many elbows
10.7"
AIR DELIVERY @ 1" WG (CFM)
17 WATTS
Avoid duct shrink
Elbow near the body
Fan
Body
0.47"
4" OUTLET
6.7"
NOISE
70 1 SONE
Minimum 18"
7.6"
6.8"
WEIGHT
8.0 LBS
Page 1 of 3