Electrical Grounding - hestan GFDSR241 Manuel D'installation

SAFETY
(continued)
DANGER
HIGH-PRESSURE GAS HIGH-PRESSURE GAS
• Keep CO 2 cylinder away from heat. The rupture disc vents at 122°F [50°C] max.
• Do not drop or throw regulator or CO 2 cylinder.
• Allow only properly trained and experienced personnel to handle high-pressure gas.
• Do not apply oil to the regulator!
DANGER
ELECTRICAL SHOCK HAZARD ELECTRICAL SHOCK HAZARD
Disconnect power before installing or servicing appliance. Failure to do so can result in death or
electrical shock.

ELECTRICAL GROUNDING

ELECTRICAL GROUNDING
• This appliance must be grounded. Grounding reduces the risk of electric
shock in the event of a short circuit.
• DO NOT ground to a gas pipe.
• DO NOT use an extension cord with this appliance.
• DO NOT have a fuse in the NEUTRAL or GROUNDING circuit. A fuse in
the NEUTRAL or GROUNDING circuit could result in an electrical shock.
ELECTRICAL SUPPLY ELECTRICAL SUPPLY
A 115 volt AC, 60 Hz, 15 Amp circuit breaker and electrical supply is required. A Ground Fault Circuit
Interrupter (GFCI) protected circuit must be used when installed outdoors.
This appliance is NOT designed for installation in manufactured (mobile) homes or recreational park
trailers.
All units are provided with a 5 ft [1.5 m] cord with three-prong grounding plug. It is imperative that
this plug be connected to a properly grounded three-prong receptacle. If the receptacle is not the
proper grounding type, contact an electrician. The receptacle must be flush or recessed into the wall
surface behind the unit.
• Never remove the grounding prong from this plug.
• Never use a 2-prong adapter.
• If a 2-prong receptacle is encountered, or a longer power cord is required, contract a qualified
electrician to have it replaced in accordance with applicable electrical codes.
Inspect the electrical cord and plug for damage prior to energizing the unit to
avoid potential electric shock.
NOTICE
The unit must NOT be totally enclosed or damage may occur. Air circulation must not
be restricted. The condenser at the cabinet front must be provided with a minimum of
2" [5 cm] air space. Be sure to provide access so the front cover can be removed to clean the condenser.
Do not attempt to operate the equipment on any power source / voltage other
than that listed on the Electrical Specification Plate attached to the unit.
DANGER
Do not store flammable liquids (i.e. Gasoline or Lighter Fluid) or vapors near the
appliance to avoid a fire.
ADDITIONAL GENERAL INFORMATION ADDITIONAL GENERAL INFORMATION
All electrical instructions assume the outlet is located 4 - 10" [10 - 25 cm] above the floor surface.
Floor must be level in area of installation. Leg levelers are used for fine-tune adjustment only and
should not be used to compensate for floor differences exceeding 1/2" [13 mm].
©2021 Hestan Commercial Corporation
EN
5