Installation Of Dispensing Equipment; Before Installation - hestan GFDSR241 Manuel D'installation

INSTALLATION OF DISPENSING EQUIPMENT

BEFORE INSTALLATION

BEFORE INSTALLATION
Open the tapping kit box and become familiar with its components.
If the dispensing head is going to be mounted on a countertop directly above the refrigerated cabinet,
have the countertop pre-drilled using the printed template in the Appendix of this manual.
Make sure that the access hole in the refrigerated cabinet is in line with the countertop holes.
Remove any obstructions from the access hole of the refrigerator.
FILLING THE CO 2 2 CYLINDER FILLING THE CO CYLINDER
The 5 lb. CO 2 cylinder is not filled. A local welding supply store, locations that fill fire extinguishers,
local home brew shops, and sporting stores that sell paint ball guns are among the most likely places
to get your CO 2 cylinder filled.
ABOUT KEG COUPLERS (TAPS) ABOUT KEG COUPLERS (TAPS)
Your Hestan Beer Refrigerator is supplied with a low-profile coupler for "D" system kegs, commonly
used for beers of the United States and Mexico.
This coupler MUST be used when using Slim 1/4 kegs or 1/6 kegs (23-3/8" [59.4 cm] tall). If you are
using other kegs with A, G, M, S, or U couplers, you must use a standard 1/4 keg (13-7/8" [35.2 cm]
tall) to be able to fit inside the cabinet.
CLEANING THE TAP CLEANING THE TAP
Wash tapping devices thoroughly. Flush beer and faucet lines, as well as the tapping device (keg
coupler) with fresh water.
A beer tap cleaning kit AGDFK is available for purchase separately.
See instructions on the
following pages to properly
install the tapping equipment on
your Hestan unit.
INSTRUCTIONS
CLEANING JAR
w/ HAND PUMP
SPANNER
WRENCH
BEER TAP CLEANING KIT (AGDFK)
©2021 Hestan Commercial Corporation
EN
FAUCET
BRUSH
BALL
LIFTER
CLEANING
CHEMICAL
53g
11