Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Floor drain system
The oor drain system requires a siphon break that may be
purchased separately. See "Tools and Parts."
The siphon break must be a minimum of 28" (710 mm) from
the bottom of the washer. Additional hoses might be needed.
28" min.
(710 mm)
Electrical Requirements
A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical
I
supply is required. A time-delay fuse or circuit breaker is
recommended. It is recommended that a separate circuit
serving only this washer be provided.
This washer is equipped with a power supply cord having
I
a 3 prong grounding plug.
To minimize possible shock hazard, the cord must be
I
plugged into a mating, 3 prong, grounding-type outlet,
grounded in accordance with local codes and ordinances.
If a mating outlet is not available, it is the personal
responsibility and obligation of the customer to have the
properly grounded outlet installed by a quali ed electrician.
If codes permit and a separate ground wire is used, it is
I
recommended that a quali ed electrician determine that
the ground path is adequate.
Do not ground to a gas pipe.
I
Check with a quali ed electrician if you are not sure
I
the washer is properly grounded.
Do not have a fuse in the neutral or ground circuit.
I
6
All manuals and user guides at all-guides.com
Back view
IMPORTANT: Position the washer so that the rear of the washer
is within approximately 3 ft. (900 mm) of its nal location.
There are 4 shipping bolts in the rear panel of the washer that
support the suspension system during transportation. These bolts
also retain the power cord inside the washer until the bolts are
removed.
1. Keep the washer in the upright position while removing the
INSTALLATION INSTRUCTIONS
Remove Transport System
shipping bolts.
Shipping bolt
Shipping bolt
Shipping bolt with plastic spacer
Publicité
Table des Matières
