Generac Mobile Link Manuel Du Propriétaire Et Manuel D'installation page 27

20. For units equipped with the Evolution or Sync 2.0 controllers, the
accessory port is located underneath the controller and is cov-
ered with a decal that says "Accessory Prt 1". Remove the decal
and install the harness. Figure 3-16.
NOTE: On PowerPact models, the accessory port is located under
the controller, and visible through the battery door after the plate is
removed.
21. The power wires of the harness consist of a black negative (-)
wire and a fused yellow positive (+) wire. See Figure 3-17.
Mobile Link
Figure 3-16. Accessory Port 1
Figure 3-17. Harness Power Wires
21