Getting Started; General Information - Medisana WST Mode D'emploi

All manuals and user guides at all-guides.com
3.1

Getting started

3.2
General
information
1. Place the device on a level surface that is resistant to water. As a precaution,
put a protective sheet underneath to prevent any damage to the delicate
surface.
2. Remove the stones from the packaging and wash them one by one. Pay
particular attention to jagged edges, sharp or broken stones. There is a
danger of injury. These stones may also scratch wash basins or sinks.
CAUTION
Make sure you clean the water container and the stones before
each use, as well as changing the water.
3. First place the insert in the container to protect the water container. Then
carefully place the stones in the water container one by one
4. Fill up the container with water until all the stones are covered. The water must
not exceed or come below the mark for the maximum and minimum level
. Do not put in hot or boiling water. This will damage the device. Put the lid
on the water container.
5. Plug the power supply into the mains socket. The green
indicators light up. Turn the dial
6. Once the set temperature on the dial is reached, the red LED light goes out. It
takes approx. 45 minutes to reach the maximum temperature setting for water
at 20 °C.
7. The stones have reached the required temperature. Using the tongs supplied
take the stones carefully out of the container. Be careful not to drop the
stones when using the tongs as they could cause injury.
1. Before you use the wellness stones, check their temperature with your fingers.
If the stones are not too hot, put them in your hand to check they are
pleasantly warm in your hand. Leave the stones to cool down briefly.
2. If you do not want to use the stones when wet, dry them with a clean cloth.
3. Put stones that have cooled off back in the water container so they can be
warmed up again within a few minutes.
4. When you have finished, disconnect the power supply from the mains socket.
5. Take out all the stones one by one and dry them with a cloth.
6. Empty the water container and dry it carefully.
3 Operating
to the required position.
GB
.
and red LED
13