Miele STB 201 Mode D'emploi page 9

Using the Turbobrush
The Turbobrush is particularly suitable
for vacuuming cut pile carpeting and is
operated by the suction power of the
vacuum cleaner.
It has a rotating roller brush which is
very effective at picking up thread,
hairs and fluff and four rollers maintain
the brush 1.5 mm away from the floor.
The normal foorhead or one of the Miele
floorbrushes should be used for
cleaning hard floors, such as tiled or
parquet floors.
It is also important to observe the
flooring manufacturer's cleaning and
care instructions.
The following should not be
vacuumed using the Turbobrush:
– Floor surfaces with a variable or
uneven profile. The brush might
come into contact with the floor and
cause damage.
– Carpets such as saxony with very
long-pile, berber and sheepskin
rugs, and valuable hand-knotted
carpets, e.g. Persian and similar.
There is a danger of the threads
being pulled out. If in doubt, contact
the carpet manufacturer/retailer.
All manuals and user guides at all-guides.com
Using the Turbobrush
^ To achieve the best effect, pass the
For carpets with fringes always draw
the Turbobrush from the carpet across
the fringe towards the rest of the floor.
Turbobrush slowly backwards and
forwards over the carpet or floor
covering.
en - Use
9