Setting The Low Cut Filter - Panasonic WX-ST200P Mode D'emploi

Setting the low cut filter

The low cut filter can help reduce some of the low-frequency noise collected by the
microphone unit.
The low cut filter applies a -6 dB/octave gain on frequencies lower than around 200 Hz.
3
Battery cover
1
Make sure that the [PWR] indicator is off
2
Remove the battery cover
Turn the battery cover to the left and slide it downwards to remove it.
3
Set the low cut filter
Set the low cut filter switch. Use the tip of a pen, screwdriver, or other narrow pointed
object to control the switch.
The settings for the switch are as follows.
[LCF OFF]: Disable the low cut filter (factory default)
[LCF ON]: Enable the low cut filter
4
Place the battery cover back on
Place the battery cover onto the microphone and turn it right to fix it.
⚫ This setting can also be changed while the power is set to ON, but make
sure to turn down the volume on the power amplifier or mixer to avoid
Important
excessive noise.
2
Loosen
4
Tighten
1
Power indicator
17