Panasonic WX-ST200P Mode D'emploi page 13

④ Power indicator [PWR]
Shows the battery status.
On (green):
On (orange):
On (red):
Off:
Blinking (green):
Blinking (orange): No signal (outside of the connection area between microphone
Blinking (red):
Alternately blinking (orange/green) : Confirming pairing
⚫ The indication of the remaining battery level will change according to the
battery type (either alkaline dry-cell or Ni-MH) selected through the
microphone battery setting switch on the wireless receiver.
⚫ Setting the battery type switch to the wrong position will not interfere with the
operation of the microphone, but it may result in the orange and red
indicators lighting up for too long or too short, displaying an incorrect reading
of the remaining battery level.
⚫ The microphone battery type setting on the wireless receiver applies to all
microphones paired with it, and cannot be changed individually.
Refer to the wireless receiver manual for further details.
⑤ Power switch [ON]
Turns the microphone ON/OFF.
Turning the switch to [ON] will power the microphone, and audio from the microphone
unit will be transmitted.
Turn the switch in the direction opposite to [ON] to power the microphone OFF.
⑥ Battery cover
Rotate the battery cover to the left and slide it downwards to remove it.
⑦ External input connector [AUDIO IN]
Transmits the audio from the external device to the receiver (page 29).
When an external device is connected to this connector, audio from the microphone unit
will not be transmitted to the receiver.
Power ON
Power ON (less than one hour of battery runtime remaining)
Battery almost depleted (recharge or exchange the battery)
Power OFF
There is either another microphone turned ON and registered on
the same channel, or the connection is otherwise close to being
lost.
and antenna)
Pairing mode
Microphone unpaired or failed to pair with a receiver
⚫ See "Pairing" (page 19).
13