Panasonic WX-ST200P Mode D'emploi page 21

3
Pair the microphone
With the microphone powered on, keep the [REG]
button pressed for at least two seconds to start
pairing. (the [PWR] indicator will blink orange).
If pairing is completed successfully, the [PWR]
indicator on the microphone will switch to the
normal status according to the remaining battery
level (green, orange, or red), and the [REG]
indicator on the paired channel on the wireless
receiver lights green for one second and then goes
off.
⚫ If pairing could not be completed successfully,
the [PWR] indicator on the microphone will blink
red. In that event, place the microphone as close
as possible to the antenna and try pairing it
again. (Pairing may fail if the microphone is too
far away from the antenna or under bad
connection conditions.)
4
Place the battery cover back on
Place the battery cover onto the microphone and turn it right to fix it.
⚫ The [REG] button is invalid if the channel to which microphone is paired and
if that microphone is in use. Turn the currently paired microphone power
OFF, then you can pair a different microphone to the channel that is already
in use.
⚫ The wireless receiver cannot enter pairing mode on multiple channels
simultaneously.
⚫ When a channel on the wireless receiver is in pairing mode, all other
channels can still be used as normal.
Power indicator
Register button
21