Panasonic WX-ST200P Mode D'emploi page 14

Parts and their names
⑧ Space to place stickers for microphone identification
Place the included microphone identification stickers here. Using the stickers makes it
easier to identify microphones.
⑨ Connector for configuration and maintenance [SET] (inside the battery cover)
Use micro USB 2.0 type B connector to connect to the wireless receiver.
Connects through a USB 2.0 cable (micro type B male to type A male; locally procured)
and a conversion cable (type A female to micro type B male; locally procured).
⑩ Low Cut Filter setting switch [LCF OFF/ON] (inside the battery cover)
Set the low cut filter to audio from the microphone unit (page 17).
[LCF OFF]: Disable the low cut filter (factory default)
[LCF ON]: Enable the low cut filter
⑪ Unused
⑫ Pairing button [REG] (inside the battery cover)
This button controls the pairing between the microphone and the receiver.
⚫ Pairing: While the power switch is set to ON, keep the [REG] button pressed for more
than two seconds to enter pairing mode (page 19).
⚫ Pairing confirmation :
Press the [REG] button once while the power switch is set to ON to enter
pairing confirmation mode (page 25). The pairing confirmation mode lasts
for five seconds on both the microphone and the receiver, after which both
will go back to their normal operation mode.
14