Setting The Microphone Sensitivity - Panasonic WX-ST400P Mode D'emploi

Setting the microphone sensitivity

Sets the sensitivity to audio collected by the microphone unit.
1
Make sure that the [PWR] indicator is off
2
Remove the battery cover
Press on the portion labeled as
downwards to remove it.
3
Set the microphone sensitivity
Set the sensitivity setting switch. Use the tip of a pen, screwdriver, or other narrow
pointed object to control the switch. The settings for the switch are as follows.
[SENS L]: Low sensitivity (factory default)
[SENS H]: High sensitivity
4
Place the battery cover back on
Slide the battery cover upwards to place it back on.
⚫ Changing this setting while the microphone is turned ON could lead to
noise. Turn down the volume on the power amplifier or mixer before
Important
changing this setting.
⚫ Set the sensitivity to "Low" when the microphone unit is close to the mouth.
⚫ Set the sensitivity to "High" when the microphone unit is far from the mouth
or when the volume of voice is low.
3
A
4
2
Battery cover
on the back of the battery cover and slide the cover
1
Power indicator
19