Panasonic WX-ST400P Mode D'emploi page 21

2
Set the wireless receiver to pairing mode
Make sure that the [POWER] indicator on the wireless receiver lights green, then press
for at least two seconds the [REG] button of the channel to which you want to pair a
microphone.
When the wireless receiver is in pairing mode, the [REG] indicator of the channel
whose [REG] button has been pressed will blink orange. Pairing mode lasts for 30
seconds, so pair the microphone within this time.
Power indicator
3
Pair the microphone
With the microphone powered on, keep the [REG]
button pressed for at least two seconds to start pairing.
(the [PWR] indicator will blink orange).
If pairing is completed successfully, the [PWR]
indicator on the microphone will switch to the normal
status according to the remaining battery level
(green, orange, or red), and the [REG] indicator on
the paired channel on the wireless receiver lights
green for one second and then goes off.
⚫ If pairing could not be completed successfully, the
[PWR] indicator on the microphone will blink red. In
that event, place the microphone as close as
possible to the antenna and try pairing it again.
(Pairing may fail if the microphone is too far away from
the antenna or under bad connection conditions.)
4
Place the battery cover back on
Place the battery cover back onto the product.
⚫ The [REG] button is invalid if the channel to which microphone is paired and
if that microphone is in use. Turn the currently paired microphone power
OFF, then you can pair a different microphone to the channel that is already
in use.
⚫ The wireless receiver cannot enter pairing mode on multiple channels
simultaneously.
⚫ When a channel on the wireless receiver is in pairing mode, all other
channels can still be used as normal.
Register indicator
Register button
Power indicator
Register
button
21