Panasonic WX-ST400P Mode D'emploi page 13

① Microphone connector
The connector into which the microphone is plugged.
② Charge indicator [CHG] (red)
Shows the charge status.
On: Charging
Off: Charging complete or the microphone is not set correctly on the charger.
Blinking: Charging error
⚫ The microphone may contain a dry-cell or deteriorated rechargeable
battery, or the battery may be absent. Make sure that the proper type of
battery is inserted.
⚫ The battery may be outside of the operating temperature range. Make sure
that the battery is within the operating temperature range.
③ Power indicator [PWR]
Shows the battery status.
On (green):
On (orange):
On (red):
Off:
Blinking (green): There is either another microphone turned ON and registered on the
Blinking (orange): No signal (outside of the connection area between microphone and
Blinking (red):
Alternately blinking (orange/green) :
⚫ If the charger cannot directly contact the microphone because
of an obstruction, the [CHG] indicator will remain off and the
[ERROR] indicator on the charger will either light up or blink. In
that case, remove any foreign matter that is obstructing the
connection and re-insert the microphone into the charger.
Power ON
Power ON (less than one hour of battery runtime remaining)
Battery almost depleted (recharge or exchange the battery)
Power OFF
same channel, or the connection is otherwise close to being lost.
antenna)
Pairing mode
Microphone unpaired or failed to pair with a receiver
⚫ See "Pairing" (page 20).
Confirming pairing
13