Depaepe Telecom Securphone Notice D'utilisation page 28

Settings programming
Securphone
Note :
- Programming access code = 0000
- Dialling = Tone
- Hook-Flash duration = 270 ms
- Pulse mark-break ratio = 66/33
- Access to memory programming = unlocked
- Call barring = unlocked
To change settings, proceed as follows:
1) Make sure the telephone is connected to a powered C.O. or PABX line.
2) Depress « PGR » key located on the small keypad (Located at the back of the
unit).
3) While keeping « PGR » key depressed, pick-up the handset.
4) Release « PGR » key.
5) 2 sharp « beep » tones will confirm entering the settings programming mode.
6) Enter the 4 digits programming access code with the keypad (factory pre set
code is : 0000)
This code can be modified (see « LIST OF SETTINGS » section, pages 29-30).
7) If the right code is entered, 2 short « beep » tones will be heard and the access
to settings, changes will be authorized.
If a wrong code is entered, a low « beep » tone will be heard and the unit will
return to talk mode.
8) Enter the 2 digits selected setting access code (see « LIST OF SETTINGS »
section pages 29-30)
9) 2 sharp « beep » tones confirming the selection will be heard.
10) Enter your custom setting choice or the code or number to store.
11) Terminate your setting by depressing « PGR » key.
12) 2 sharp « beep » tones will confirm the storage of your new setting.
13) For other settings, proceed with operations 2 up to 11.
Caution: Do not stop the programming process even if you hear busy tone or
line
All manuals and user guides at all-guides.com
standard factory settings come with :