Depaepe Telecom Securphone Notice D'utilisation page 27

NOTE: In case of wrong operation, a long "beep" sound is emitted. Replace the
handset on hook and start again from the beginning.
NOTE: To erase a number stored in memory, proceed from 1 to 4, skip section 5
(Do not enter any digit) and terminate as in 6 and 7.
Securphone
NOTE:
come with "Urgence" mode. In case of wrong operation, see « LIST OF
SETTINGS » pages 29-30 and check that "Urgence" mode is selected.
Setting access code:
Setting choice:
Securphone
NOTE:
in emergency mode if a "Total Reset" is done.
- Setting access code:
- Setting choice:
Caution: Do not stop the programming process even if you hear busy tone or
line
Securphone
-Mode 2
Securphone
1) Make sure
2) Lift the handset.
3) Depress "PGR" key located on the small keypad.
A "beep" sound should be heard through the receiver.
4) Dial the telephone number to store including *, # or "Pause" if needed (22
digits maxi).
5) Press the memory location "M, M2, M3, M4".
A double "beep" sound confirms the right storage.
6) Replace the handset on hook.
Repeat operation 3 to 5 for the other memories.
NOTE: In case of wrong operation, a long "beep" sound is emitted. Replace the
handset on hook and start again from the beginning.
NOTE: To erase a number stored in memory, proceed from 1 to 3, skip section 4
(Do not enter any digit) press the memory to erase as in 5 and terminate as in 6.
Securphone
NOTE:
case of wrong operation, see « LIST OF SETTINGS » pages 29-30 and check that
"Normal" mode is selected.
Setting access code:
Setting choice
Caution: Do not stop the programming process even if you hear busy tone or
line
All manuals and user guides at all-guides.com
"Urgence" and "Urgence à clavier" model factory settings
04
Urgency:1
Urgence (Emergency) model needs to be re-programmed
Urgency: 1
1, 2, 3 or 4
is connected to the line.
1, 2, 3 or 4 factory settings come with "Normal" mode. In
04
Normal: 0
04