Making Ice Cubes; Freezer Compartment; Replacing The Interior Light Bulb; Cleaning And Care - Beko RDSA280K20S Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

EN
Small quantities of food up to 1/2 kg. (1 lb) can be
frozen without adjusting the temperature control
knob. Take special care not to mix already frozen
food and fresh food.

Making ice cubes

Fill the ice - cube tray 3/4 full with water and place it
in the freezer. Loosen frozen trays with a spoon
handle or a similar implement; never use sharp-
edged objects such as knives or forks.
Defrosting
A) Fridge compartment
The fridge compartment defrosts automatically. The
defrost water runs to the drain tube via a collection
container at the back of the appliance (Item 5).
During defrosting, water droplets may form at the
back of the fridge compartment where a concealed
evaporator is located. Some droplets may remain
on the liner and refreeze when defrosting is
completed. Do not use pointed or sharp-edged
objects such as knives or forks to remove the
droplets which have refrozen. If, at any time, the
defrost water does not drain from the collection
channel, check that no food particles have blocked
the drain tube. The drain tube can be cleared with a
pipe-cleaner or similar implement. Check that the
tube is permanently placed with its end in the
collecting tray on the compressor to prevent the
water spilling on the electric installation or on the
floor (Item 6).
B) Freezer compartment
Defrosting is very straightforward and without mess,
thanks to a special defrost collection basin.
Defrost twice a year or when a frost layer of around 7
(1/4") mm has formed. To start the defrosting
procedure, switch off the appliance at the socket
outlet and pull out the mains plug. All food should be
wrapped in several layers of newspaper and stored in
a cool place (e.g. fridge or larder). Containers of
warm water may be placed carefully in the freezer to
speed up the defrosting. Do not use pointed or sharp-
edged objects, such as knives or forks to remove the
frost. Never use hairdryers, electrical heaters or other
such electrical appliances for defrosting. Sponge out
the defrost water collected in the bottom of the
freezer compartment. After defrosting, dry the interior
thoroughly. Insert the plug into the wall socket and
switch on the electricity supply.

Replacing the interior light bulb

To change the Bulb/LED used for illumination of
your refrigerator, call your Authorised Service. The
lamp(s) used in this appliance is not suitable for
household room illumination. The intended
purpose of this lamp is to assist the user to place
foodstuffs in the refrigerator/freezer in a safe and
comfortable way.
The lamps used in this appliance have to withstand
extreme physical conditions such as temperatures
below -20°C.

Cleaning and care

1. We recommend that you switch off the
appliance at the socket outlet and pull out the
mains plug before cleaning.
2. Never use any sharp instruments or abrasive
substances, soap, household cleaner, detergent or
wax polish for cleaning.
3. Use luke warm water to clean the cabinet of the
appliance and wipe it dry.
4. Use a damp cloth wrung out in a solution of one
teaspoon of bicarbonate of soda to one pint of
water to clean the interior and wipe it dry.
5. Make sure that no water enters the
temperature control box.
6. If the appliance is not going to be used for a
long period of time, switch it off, remove all food,
clean it and leave the door ajar.
7. We recommend that you polish the metal parts
of the product (i.e. door exterior, cabinet sides) with
a silicone wax (car polish) to protect the high
quality paint finish.
8. Any dust that gathers on the condenser, which
is located at the back of the appliance, should be
removed once a year with a vacuum cleaner.
9. Check door seals regularly to ensure they
areclean and free from food particles.
10. Never:
• Clean the appliance with unsuitable material; eg
petroleum based products.
• Subject it to high temperatures in any way,
• Scour, rub etc., with abrasive material.
11. Removal of dairy cover and door tray:
• To remove the dairy cover, first lift the cover up
by about an inch and pull it off from the side where
there is an opening on the cover.
• To remove a door tray, remove all the contents
and then simply push the door tray upwards from
the base.
12. Make sure that the special plastic container at
the back of the appliance which collects defrost
water is clean at all times. If you want to remove
the tray to clean it, follow the instructions below:
• Switch off at the socket outlet and pull out the
mains plug.
• Gently uncrimp the stud on the compressor, using
a pair of pliers, so that the tray can be removed.
• Lift it up.
• Clean and wipe it dry.
• Reassemble, reversing the sequence and
operations.
13. Large accumulation of ice will impair the
performance of the freezer.
4
Instruction for use

Publicité

Table des Matières
loading

Table des Matières