Starting And Stopping - Maruyama BL3200 Manuel D'opérateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Starting and Stopping

Before Starting the Engine
1. Fill the fuel tank as instructed in the "Before
Operation" section of this manual (page US 11).
2. Rest the Handheld Blower on the ground.
3. Make sure that the area is clear of any broken glass,
nails, wire, rocks or other debris.
4. Keep all bystanders, children and animals away from
the working area.
Cold Starting Procedure
This Blower is equipped with a fuel primer and a choke
system. To start a "cold" engine properly, perform the
following procedure:
1. Pump the primer bulb at the bottom of the carburetor
until fuel can be seen flowing through the fuel return
line to the fuel tank. (Flowing fuel should be almost
clear, not foamy or full of bubbles.)
2. Move the choke lever to the closed (
3. Move the stop switch to the "ON" position.
4. (1) Press the throttle trigger.
(2) Move the throttle setting lever to half position.
(3) Release the throttle trigger.
(4) Release the throttle setting lever.
5. Hold the Handheld Blower with your left hand and
press it down firmly. Hold the assist handle with your
right foot gently.
IMPORTANT: Be careful not make damages to
fuel tank or the blower by your foot.
) position
6. Pull the starter grip. Grasping the starter grip, slowly
pull the starter cord out until you feel resistance, then
pull the cord quickly and powerfully. Pull the starter
grip until the engine starts.
US- 13 -
(Throttle is kept in half position.)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Bl32Bl32-1

Table des Matières