How To Use The Control Panel - Masterbuilt MES 230G Mode D'emploi

Bluetooth fumoir électrique numérique

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

On/Off

Meat Probe

Light

Note: Direct sunlight may interfere with ability to read LED display. Block light if needed.

To set temperature:

• Press ON/OFF button.

• Press SET TEMP button once-LED display will blink.

• Use up or down arrows to set temperature.

• Press SET TEMP button again to lock in temperature.

Note: Heating will not begin until timer is set.

To set timer:

• Press SET TIME button once-LED display for hours will blink.

• Use up or down arrows to set hours.

• Press SET TIME button again to lock in hours-LED display for minutes will start blinking.

• Use up or down arrows to set minutes.

• Press SET TIME to lock in minutes and start cook cycle.

Heat will turn off when time has expired.

To use meat probe (If featured):

• Insert meat probe into center of meat to get most accurate reading.

• Press and hold MEAT PROBE button-LED display will show internal temperature of meat.

• Once MEAT PROBE button is released-LED display will return to internal smoker temperature or remaining time.

To use light:

• Press LIGHT button to turn light on.

• Press LIGHT button to turn light off.

To RESET control panel:

If control panel shows an error message, turn electric smoker off. Unplug unit from outlet. Wait ten seconds. Plug unit back into

outlet then turn electric smoker on. This will reset control panel.

How to pair your Bluetooth smoker:

1. Go to the Apple App Store or Google Play Store on your device(s) and search for "Masterbuilt"

or go to www.masterbuilt.com/apps.

2. Download the Masterbuilt app.

3. Once the download is complete, open the Masterbuilt app and follow the instructions for pairing

your Bluetooth smoker and mobile device(s).

4. For troubleshooting advice please visit www.masterbuilt.com/apps.