Operation - Unold 86830 Notice D'utilisation

Masquer les pouces Voir aussi pour 86830:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
precisely above the bores on the
motor housing.
6.
Fasten the basket cover with the
screws.
7.
Place the impeller on the axle
on the motor housing, and fix it
in place with the screw. The ring
must sit on the flattened side of
the axle.
8.
Connect the front basket cover to
the rear basket cover, by hooking
the hook of the front basket cover

OPERATION

1.
Ensure that the appliance is stan-
ding on a suitable, level subst-
rate, and has been set up so that
it is safe and stable.
2.
Plug the power cord into an elec-
trical outlet.
Adjusting the tilt angle
3.
Slightly
unscrew
screws (see illustration).
5.
Fix the fan in place in the set tilt
angle by tightening the knurled
screws.
Setting the speed
6.
Switch on the appliance by selec-
ting one of the three speed levels
All manuals and user guides at all-guides.com
the
knurled
4.
Tilt the bas-
ket cover to the
desired
angle.
Caution: Only tilt
the cover in the
intended
range
and not beyond
the point of tan-
gible
resistance,
to avoid damaging
the appliance.
into the groove on the rear basket
cover.
9.
At the bottom of each of the two
covers there is a hole for the fas-
tening screw. These holes must
be precisely in line, one above the
other.
10. Fix the two basket covers in place
by closing the clamps on the edge.
11. To secure the cover, firmly tighten
the fastening screw with nut on
the underside of the cover.
and press the appropriate button.
The speed regulator is on the rear,
top side of the motor housing.
ƒ Level 1: Light breeze
ƒ Level 2: Moderate breeze
ƒ Level 3: Strong breeze
ƒ Level
"0"
appliance.
7.
You can change the speed levels
at any time.
Swing function/oscillation function
8.
Press the oscillation button on the
rear of the appliance head down-
ward (see illustration). The appli-
ance now swings autonomously.
9.
If you want to switch off the swing
function, pull the oscillation but-
ton upward.
Switching off
10. To switch off the appliance,
switch the speed regulator to "0".
When you are no longer using the
appliance, unplug the plug from
the electrical outlet.
switches
off
the
15

Publicité

Table des Matières
loading

Table des Matières