Installation; Stacking Or Flying The 12Xt; Connecting Speakers - L-Acoustics 12XT Manuel D'utilisation

6

INSTALLATION

6.1

Stacking or flying the 12XT

The integrated rigging components and the wedge-shaped cabinet design of the 12XT enclosure (Figure 3) allow for
various setups such as:
•
Wall or ceiling-mounting using the L-ACOUSTICS
• Wall or ceiling-mounting using the OMNIMOUNT
• Flying using the L-ACOUSTICS
• Mounting to a 35 mm/1.38 in. pole stand using the integrated pole socket.
• Stacking with two fixed angle settings of 30° and 60° with regard to the vertical.
* A safety eye-bolt accessory can be added using the M8 insert located on the rear face of the 8XT enclosure.
Note: The "M8" notation refers to the European standard (see applicable external documentation).
!
Refer to the "XT and P - Rigging Procedures'' manual to get acquainted with the XT Range
specific rigging procedures.
WARNING
6.2

Connecting speakers

The 12XT enclosure is driven and powered by the dedicated L-ACOUSTICS
amp channel can drive one PASSIVE 12XT enclosure. Channels 1 and 3 can drive one or two (in parallel) ACTIVE
12XT enclosures. For more details please refer to the "LA4 - User Manual'' also available on the L-ACOUSTICS
web site @ www.l-acoustics.com.
ACTIVE or PASSIVE setting is selectable by a switch located behind the logo side handle of the
enclosure. Active setting is available when the white mark on the switch is visible through the handle
!
(Figure 4a). Passive setting is available when the white mark is not visible (Figure 4b).
To select ACTIVE or PASSIVE setting:
IMPORTANT
1. Roll both rubber bands back away from the grill.
2. Remove screws securing the grill.
3. Remove the grill.
4. Select appropriate switch setting (clockwise=PASSIVE, counterclockwise=ACTIVE).
5. Reverse steps from 1 to 3 to replace grill.
Figure 4: The ACTIVE/PASSIVE switch positions (visible from the logo side handle)
12XT_UM_ML_1.2
All manuals and user guides at all-guides.com
® XTLIFTBAR rigging accessory.*
Note: The factory 12XT default setting is ACTIVE setting.
(a) ACTIVE setting
w w w . l - a c o u s t i c s . c o m
® ETR12 mounting accessory.*
® 120.0 SERIES mounting accessories (four M8 inserts).*
®
LA4 amplified controller. Each LA4
(b) PASSIVE setting
EN
®
9 en