Installation; Flying Or Stacking The 8Xt; Connecting Speakers - L-Acoustics 8XT Manuel D'utilisation

8 8 8 8 XT XT
XT XT
COAXIAL ENCLOSURE COAXIAL ENCLOSURE COAXIAL ENCLOSURE COAXIAL ENCLOSURE
user manual user manual
user manual user manual
VERSION 1.3
6 6 6 6

INSTALLATION

INSTALLATION
INSTALLATION INSTALLATION
6.1

Flying or stacking the 8XT

The integrated rigging components and the wedge-shaped cabinet design of the 8XT enclosure (Figure 3) allow various
setups such as:
Wall or ceiling-mounting using the L-ACOUSTICS
• • • •
Wall or ceiling-mounting using the OMNIMOUNT
• • • •
Mounting to a 35 mm/1.4 inch pole stand using the integrated pole socket.
• • • •
Stacking with two fixed angle settings of 30° and 40° with regard to the vertical.
• • • •
* A safety eyebolt accessory can be added using the M8 insert located on the rear face of the 8XT enclosure.
Note: The "M6" and "M8" notations refer to the European standard (see applicable external documentation).
!
Refer to the "XT and P'' rigging procedures manual to get acquainted with the XT range
specific procedures.
WARNING
6.2

Connecting speakers

The 8XT enclosure is driven and powered by the dedicated L-ACOUSTICS
LA4 / LA4X amp channel can drive one or two (in parallel) 8XT enclosures. For more details please refer to the
LA4 / LA4X user manual also available on the L-ACOUSTICS
The 8XT enclosure is equipped with two 4-point Speakon
second 8XT enclosure in parallel using one of the L-ACOUSTICS
The same cables are recommended to connect the 8XT enclosure to the LA4 / LA4X amplified controller (see Figure 2
and Figure 4).
!
A maximum of two 8XT enclosures can be connected per LA4 / LA4X output channel.
CAUTION
®
The L-ACOUSTICS wiring convention is as follows:
®
Speakon connector labels
8XT_UM_ML_1.4
1+
1-
2+
2-
w w w . l - a c o u s t i c s . c o m
®
ETR8-2 mounting accessory.*
®
30.0 SERIES mounting accessories (four M6 inserts).*
®
LA4 / LA4X amplified controller. Each
®
web site at www.l-acoustics.com.
®
connectors wired in parallel, allowing connection with a
®
SP.7, SP10, or SP25 cables.
Connection to transducers
IN +
IN -
Not used
Not used
10 en 10
10 10