Cleaning The Burner Assembly - Hkoenig plx830 Manuel D'instructions

CLEANING THE BURNER ASSEMBLY

Turn the gas OFF at the control knob and disconnect the
cylinder.
Remove cooling griddle.
Clean the burner with a soft brush or blow clean with
compressed air and wipe with a cloth.
Clean any clogged ports with a pipe cleaner or stiff wire
(such as an opened paper clip).
Inspect burner for any damage (cracks or holes). If damage
is found, replace with a new burner. Reinstall the burner,
check to ensure that the gas valve orifices are correctly
positioned and secured inside the burner inlet (venturi).
In some cases your plancha will light back because of an
insect crawling inside the burner venturi or a spider
spinning its web inside the burner. This can be rectified by
using a bottle brush inserted through the burner venturi and
pushing it into the burner over the burner length. If condition
persists consult your gas dealer.
SERVICING
Your gas plancha should be serviced annually by a
competent registered person.
CAUTION :
Do not dispose of this product as it has with other household products. There is a separation of
this waste product into communities, you will need to inform your local authorities about the
places where you can return this product. In fact, electrical and electronic products contain
hazardous substances that have harmful effects on the environment or human health and should