Hkoenig plx830 Manuel D'instructions page 11

Make 2-3 fluid ounces of leak detecting solution by mixing one part washing up liquid with 3 parts
water.
Ensure the control valve is "OFF".
Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the connections are
secure then turn ON the gas.
Brush the soapy solution on to the hose and all joints. If bubbles appear you have a leak, which
must be rectified before use.
Retest after fixing the fault. Turn OFF the gas at the cylinder after testing.
If detected leakage can not be rectified, do not attempt to cure leakage but consult your gas dealer.
In the event of gas leakage, turn off the gas supply.
REGULATOR AND HOSE
The items have supplied together with plancha. Use only regulators and hose approved for LPG at
the above pressures (See page 2). The life expectancy of the regulator is estimated as 10 years. It
is recommended that the regulator is changed within 10 years of the date of manufacture.
The use of the wrong regulator or hose is unsafe; always check that you have the correct items
before operating the plancha.
The hose used must conform to the relevant standard for the country of use. The length of the hose
must be 1.5 meters (maximum). Worn or damaged hose must be replaced. Ensure that the hose is
not obstructed, kinked, or in contact with any part of the plancha other than at its connection.
The hose should comply with the standard EN16436.
The hose should not be twisted or kinked when attached to the gas cylinder.
Flexible metal or rubber pipe, used to connect the appliance with the LPG cylinder must be
changed within the prescribed intervals and according to the National Rules in force.
No part of the hose should touch any part of the appliance.
STORAGE OF THE APPLIANCE
Storage of an appliance indoors is only permissible if the cylinder is disconnected and removed
from the appliance. When the appliance is not to be used for a period of time it should be stored
in its original packaging in a dry dust free environment.
GAS CYLINDER
The appliance can be used with any gas cylinder of weights between 4.5KGS and 15 KGS butane
and 3.9 KGS to 13 KGS propane. The gas cylinder should not be dropped or handled roughly! If
the appliance is not in use, the cylinder must be disconnected. Replace the protective cap on the
cylinder after disconnecting the cylinder from the appliance.
Cylinders must be stored outdoors in an upright position and out of the reach of children. The
cylinder must never be stored where temperatures can reach over 50°C.