Remote Control - Samsung DVD-R120 Manuel De L'utilisateur

Remote Control

The remote control doesn't work.
Point the remote control at the remote
Checkpoint 1
control sensor on your DVD recorder.
Allow for proper distance. Remove
obstacles between your DVD recorder
and the remote control.
Check whether the batteries are empty.
Checkpoint 2
Check for the TV or DVD button.
Checkpoint 3
Other
I forget my password for parental supervision.
Press the
Checkpoint 1
the Recorder for more than 5 seconds with
no disc in the unit. All settings including the
password will revert to the factory settings.
Do not use this unless absolutely neces-
sary. (Note that this function is possible only
when no disc is inserted.)
Is it possible to change a subtitle and an audio sig-
nal on a recorded disc?
A recorded disc is played with only the
Checkpoint 1
subtitle and the audio signal which
were selected during recording.
button on the front panel of
Other problems.
Read the table of contents and then
Checkpoint 1
find and read the section describing
your problem, follow the instructions
given.
Checkpoint 2
Turn your DVD recorder off and on.
Checkpoint 3 If the problem still persists, contact a
nearby Samsung service centre.
91
English -