Setting Up The Audio Options; Audio Options - Samsung DVD-R120 Manuel De L'utilisateur

Setting up the Audio
Options
You can connect the DVD Recorder to an external amp
or Home Theater.
Allow you to setup the Audio device and sound status
depending on the audio system in use.
1 With the unit in Stop mode/No Disc mode,
press the MENU button.
No Disc
Programme
ShowView
Timer Record
Setup
ShowView Extended : Off
MOVE OK
Press the ...† buttons to select Setup, then
2
press the OK or √ button.
No Disc
Programme
System
Clock Set
Setup
Language
Audio
Video
Parental Control
Install
MOVE OK
Press the ...† buttons to select Audio, then
3
press the OK or √ button.
Audio setup menu will be displayed.
No Disc
Programme
Digital Output
DTS
Setup
Dynamic Compression : On
MOVE OK
Press the ...† buttons to select the desired
4
audio option, then press the OK or √
button.
No Disc
Programme
Digital Output
DTS
Setup
Dynamic Compression : On
MOVE OK
34
- English
Timer Record
√ √
√ √
√ √
RETURN EXIT
Setup
√ √
√ √
√ √
√ √
√ √
√ √
√ √
RETURN EXIT
Audio
: PCM
√ √
: Off
√ √
√ √
RETURN EXIT
Audio
: PCM
PCM √ √
: Off
Bitstream √ √
√ √
RETURN EXIT
Press the ...† buttons to select the desired
5
item, then press the OK or √ button.
Press the RETURN or œ button to return
to the previous menu.
NOTE
Press the MENU button to exit the menu.

Audio Options

Digital Output
1. PCM : Select this when you have no equipment that
can decode Dolby Digital (or MPEG-2) signal.
When you play Dolby Digital (or MPEG-2)
sound track, the digital output are converted to
PCM Stereo.
2. Bitstream : Output Dolby Digital (or MPEG-2) audio as
bitstream. Select this when your AV
receiver or AV amplifier have Dolby Digital
(or MPEG-2) Decoder.
Digital output setting is equally applied to
both Dolby Digital and MPEG-2 audio.
NOTE
LPCM sound track is always outputted as
PCM. It has no relation with Digital Output
setting.
Be sure to select the correct Digital
Output or you will hear no sound or loud
noise.
DTS
1. Off : Doesn't output DTS signal.
Select this when your AV receiver or AV
amplifier does not have DTS decoder.
2. On : Outputs DTS Bitstream via digital output when you
play DTS track.
Select this only when your AV receiver (or AV
amplifier) have DTS decoder.
When DTS soundtrack is played, sound
does not output from AV Audio Output.
NOTE
Dynamic Compression
This is only active when a Dolby Digital signal is
detected.
1. Off : You can enjoy the movie with
Dynamic Range.
2. On : When Movie soundtracks are played at low
volume or from smaller speakers, the system
can apply appropriate compression to make
low-level content more intelligible and prevent
dramatic passages from getting too loud.
the standard