Maintenance And Care; Maintenance Schedule - AL-KO 18-103.2 HD Comfort Traduction De La Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 70

Maintenance and care

When the lawn tractor is transported using trans-
port equipment (e.g. trailers towed by cars), the
mower mechanism must be supported from be-
low in order to reduce the strain on the mower
mechanism mounting.
During transport, make sure that the means of
transport has a sufficient load capacity and that
the lawn tractor is suitably secured.
10 MAINTENANCE AND CARE
Dangers during maintenance!
During all maintenance work:
Switch off the engine and remove the ignition
key.
Remove the spark plug connector.
Protective devices removed for maintenance
must be reinstalled afterwards.
DANGER OF BURNS:
Do not work on the lawn tractor until it has
cooled down. The engine, transmission and
silencer get very hot!
DANGER OF LACERATIONS:
When working on the cutters, pay attention to
Activity
Check the engine oil level
Change the engine oil
)*
Clean the air filter
Replace the air filter
Check the spark plug
Check the brake (test brak-
ing on a straight path)
Check the tyre pressure
Check the mowing blades
Check for loose parts
Check V-belts (visual check)
Clean the lawn tractor
Clean the air intake grille on
)*
the engine
Before
each use
)*
X
)*
)*
)*
X
X
X
X
X
the sharp blades. In case of mowers with
multiple blades, moving one cutter can cause
another one to move as well.
Parts are only allowed to be renewed by gen-
uine spare parts.
If in doubt, always visit a specialist workshop
or contact the manufacturer.

10.1 Maintenance schedule

The following jobs are allowed to be carried out
by the user independently. All other maintenance,
service and repair work must be carried out in an
authorised service workshop.
In addition, please also comply with the recom-
mended annual lubrication tasks as indicated in
the lubrication plan.
NOTE
It may be necessary to shorten the
maintenance intervals compared to
those stated in the table above in case
of severe loading and at high tempera-
tures.
After
After the
each use
first 5
hours
X
X
Every 25
Every 50
operating
operating
hours
hours
X
X
X
X
Each
time be-
fore put-
ting into
storage
X
X
43

Publicité

Table des Matières
loading

Table des Matières