Setting Up; Electrical Connection - SilverCrest SDI 3500 A1 Mode D'emploi

All manuals and user guides at all-guides.com

Setting up

The appliance requires unrestricted ventilation to prevent overheating. Therefore,
set up the appliance so that ...
–
–
When moving the appliance, hold it by the recessed handles 3/6.
■
■ For cooling purposes, the appliance draws in air through openings on the
base. Do not place it on textiles or fl eecy surfaces, such as tablecloths.
Operate it only on smooth surfaces.
■ Do not place it adjacent to curtains or other textiles which, due to the airfl ow,
could cling to the appliance.
■ Do not place it on surfaces which may contain ferric or steel materials.
These may become very hot.
■ Maintain a minimum distance of 1 m from appliances that are sensitive to
electromagnetic fi elds (e.g. screens, clocks, magnetic storage media, electronic
devices, etc.).
■ Wipe the hobs with a damp cloth to remove soiling sustained during trans-
portation. Wipe

Electrical connection

When you have unpacked and set up the appliance as described, connect the
plug to a mains power socket.
■ Before you connect the appliance, ensure that the connection data (voltage
and frequency) specifi ed on the data plate tally with that specifi ed on your
mains power supply.
■ The mains power socket must be protected by a 16 A circuit breaker.
■ Do not use an extension cable to connect the appliance. In the event of an
emergency, the plug must be quickly accessible.
■ Do not route the power cable over the appliance or over hot and/or sharp-
edged surfaces.
■ Ensure that the power cable cannot become trapped.
The electrical safety of the appliance is only assured when it is connected to a
correctly installed protective conductor system. Operation on a mains power
socket without a protective conductor is prohibited. If in doubt, arrange for the
house wiring to be checked by a qualifi ed electrician.
The manufacturer is not liable for damage caused in consequence of a missing
or interrupted protective conductor.
SDI 3500 A1
there is an all-round clearance of at least 10 cm, e.g. to the nearest wall,
at least 60 cm clearance above, e.g. to a suspended wall cabinet.
GB
45