GE GXSHC40N Manuel Du Propriétaire Et Instructions D'installation page 22

Programming the Water Softener
OPTIONAL CONTROL SETTINGS
The controller display has several options and
features.
LOW SALT ALARM
The LOW SALT ALARM,
when enabled, will sound
the beeper when the DAYS
TO EMPTY value is 15
days or less. To change this
setting, press and hold the MODE/SET button
for 3 seconds or hear a beep. ON (factory
default) or OFF will flash in the display. Press
the UP or DOWN
this feature ON or OFF. Press the MODE/SET
button to accept, and the display will move to
the SALT EFFICIENCY screen.
SALT EFFICIENCY
When the SALT EFFICIENCY feature is
ON, the unit will operate
at a salt efficiency of
4000 grains of hardness
removed per pound of salt.
This mode of operation
is the most efficient setting for salt usage,
because the system will tend to recharge more
often with less salt usage. Turning the feature
OFF will tend to lengthen the time between
recharge cycles, which will provide the most
efficient usage of water, but may use more salt.
The degree of difference between these two
cycles is highly dependent on the water usage
and hardness at particular installation.
NOTE: California Regulations require this
feature to be ON for installations in California.
To change the setting, press the UP
DOWN buttons to toggle this feature ON or
OFF. Press the MODE/SET button to accept,
and the display will move to the PRERINSE
ON/OFF screen.
buttons to toggle
or
PRERINSE
If your water contains
sediment, the prerinse
feature will remove
sediment from the resin
bed prior to regeneration.
Press the UP
DOWN buttons to turn
prerinse ON or OFF.
Press the MODE/SET
button to accept, and the
display will move to SET
PRERINSE TIME screen.
In this screen, you can
adjust the duration of the
prerinse, in minutes, by pressing the UP
or DOWN buttons. Press the MODE/SET
button to accept, and the display will move to
the ADD BACKWASH TIME screen.
BACKWASH AND FAST RINSE
If you experience salty tasting water after
regeneration, you may need to increase the
backwash and fast rinse times. The cycle times
during regenerations are determined by the
softener's electronic controller. However, you
may Increase the backwash and fast rinse
times. You may add up to 10 minutes.
For Backwash, you can
add up to 10 minutes
in 1 minute increments,
by pressing the UP
button, or subtract time by
pressing the DOWN
button.
For Fast Rinse, press
MODE/SET and the
display moves to the
ADD FAST RINSE TIME
screen. You can add up
to 10 minutes in 1 minute
increments, by pressing the UP
or subtract time by pressing the DOWN
button. Press the MODE/SET button to accept,
and the display will move to the Run Display
screen.
22
or
button,