Support Bar Installation - OVE AMBER Mode D'emploi

1. Slide the anchors (J) and holders (L) on both sides of the support bar (K).
2-3. Place the support bar on top of the shower enclosure at its final resting position and trace the profile of the
anchors (J) on the wall. Remove temporarIly the support bar.
4. Replace only the anchors (J) on the wall, where they were before, and mark their center on the wall using a
pencil.
5-6-7. Drill holes where the center of the anchors (J) were marked and insert a screw anchor (AA). Then using
screws (EE), screw in place the 2 wall washers.
8. Re-position the support bar on top of the shower enclosure and fix it in place by screwing the 2 anchors (J)
to their wall washers.
9. Using an allen key, fix the anchors (J) and holders (L) to finish the support bar's inStallation.
10. Install the shower handle (R) on the shower door (Q).
11. InStall the shower door's bottom rubber gasket (S).
12. Install vertical rubber gasket (U) on the right fixed panel (V).

SUPPORT BAR INSTALLATION

J
1
K
L
2
3
4
14
5
6
AA
7
EE
8
U
9
10
R
11
Q
S
12
V