Cleaning; Repairs; Returning A Unit - Julabo PURA 4 Mode D'emploi

Cleaning / repairing the unit

10.1 Cleaning

10.2 Repairs

10.3 Returning a unit:

Pos: 19 /T echnische Dokum entation/Flash CORIO/Gewäh rleistung EU @ 0 \mod_13 958 453 482 00_ 18.docx @ 435 0 @ 1 @ 1
For cleaning the bath tank and the immersed parts of the water bath,
use low surface tension water (e.g. soap suds).
Clean the outside of the unit using a wet cloth and low surface tension
water.
The JULABO Water Baths are designed for continuous operation under
normal conditions. Periodic maintenance is not required.
The tank should be filled only with a bath fluid recommended by
JULABO. To avoid contamination, it is essential to change the bath fluid
from time to time.
Before asking for a service technician or returning a JULABO instrument
for repair, please contact an authorized JULABO service station.
JULABO Technical Service
Phone: +49 (0) 07823 / 5166
Fax: +49 (0) 07823 / 5199
E-mail: service.de@julabo.com
When returning the unit:
•
Clean the unit and, if necessary, decontaminate the unit in order to
avoid endangering service personnel.
•
Attach a short fault description.
Before returning the device, please complete an online return form
at http://www.julabo.com/com/support/rma.
•
During transport the unit has to stand upright. Mark the packing
correspondingly.
•
When returning a unit, take care of careful and adequate packing.
•
JULABO is not responsible for damages that might occur from
insufficient packing.
•
JULABO reserves the right to carry out technical modifications with
repairs for providing improved performance of a unit.
45