JVC D-ILA DLA-L20U Manuel D'instructions page 54

Operating the Main Menu (Cont.)
Setting Up Channels (Cont.)
Remote control unit
OPERATE
COMPUTER VIDEO
T
VOL.
ZOOM FOCUS
W
MENU/ENTER
PAGE
BACK
PRESET
QUICK AV
ALIGN. MUTING
PAGE BACK button
CHANNEL setup menu
C H A N N E L
( A U T O )
CH L I N E S O U R C E
1 Y / C N T S C ( 4 8 0 i )
2 V I D E O P A L / S E C A M
777777777
77777
3
77777 777777777
4
77777 777777777
5
77777 777777777
6
777777777
77777
7
77777 777777777
8
77777 777777777
9
77777 777777777
10
Notes
• The selected item is shown in magenta color. Items shown
in gray color cannot be operated or set in the current mode.
• Items that can be set are different when video signals are
input and when computer signals are input.
• For dedicated source signals (corresponding frequency, etc.)
for computer signals, see page 19.
1
MENU/ENTER
button
2
Cursor buttons
3
SWNo
1
2
77
77
77
4
77
77
77
77
77
Note
• You can automatically switch the channels of the projector by
To set up a switcher number "SWNo" :
Press the cursor button 3 to move to
"SWNo".
• The selected item is shown in magenta color on the screen.
• If any "LINE" item is not selected, you cannot choose a
"SOURCE" or "SWNo" item. First, register a "LINE" item.
Press the MENU/ENTER button to set
(fix).
• The SWITCHER number setup menu is displayed on the screen.
(Switcher Number Setup menu)
Press the cursor button 2 or 3 to select
a number.
• Numbers that you can choose from are numbers from 1 to 20
and symbols "77" that signify non-registration.
• Pressing the cursor 2 makes the number smaller.
Pressing the cursor 3 makes the number larger.
• If you select "77", any "SWNo" item is not registered.
• If a channel is selected, you cannot make any settings or
changes.
Press the PAGE BACK button.
• When you press PAGE BACK, the switcher number is set, and
the display returns to the "CHANNEL setup" menu.
• Be careful that if you set the same switcher number to a few
channels and operate using the switcher number, the youngest-
number channel is switched to because channels are read in
the order of channel numbers.
specifying a switcher number through an external controller.
As an example, if switcher number 1 (SWNo 1) has been registered
to channel number 1 (CH1), specifying switcher number 1 (SWNo
1) automatically switches the projector to channel number 1 (CH1).
(For this operation, a setup is required to communicate between the
projector and the external controller.)
For information on external controllers, contact the dealer where
you purchased your projector.
S W I T C H E R
S W I T C H E R NO. 1
53