Hendi 222140 Mode D'emploi page 10

Assembling / Disassembly of the attachments
The assembly / disassembly operations of the appliance are performed with the appliance stopped and dis-
connected from the power supply.
Assembly: Model 222140:
1. Align and insert the coupling (5) of the blending
shaft (3) or the whisk (6) in the clutch (2) of the
main unit (1).
2. Screw thoroughly the blending arm (3) or whisk
(6) to the main unit (1).
Assembly: Model 222171, 222188 and 222133:
1. Align and insert the coupling (5) of the blending
shaft (3) or the whisk (4) in the clutch (2) of the
EN
main unit (1). Make sure the narrower part of the
appliance coupling fits the concave side of the
blender shaft (3) or whisk (4) arm coupling.
2. Screw the nut (6) up to fasten it firmly to the main
unit (1).
Follow the above steps in the reverse order to disassembly the accessories.
Cleaning instructions
Before cleaning always unplug the appliance form
the source of power supply.
• After using the Stick Blender in a hot mixture,
cool the blending shaft in cold water before dis-
mantling the bell from the blender shaft. Clean
the shaft immediately after use to prevent adhe-
sion of the mixture.
• Never immerse the motor unit or the handle in
water; clean with a damp cloth or a sponge.
• Blender shaft and bell cleaning: Place the blend-
ing arm and the bell in a suitable container with
clean water and switch on for a few seconds.
10
All manuals and user guides at all-guides.com
• WARNING: Always dry the blades thoroughly after
• Never immerse the whisk holder in water; clean
• After use clean the appliance with a detergent or
5
4
1
3
2
5
1
3
2
cleaning to avoid rust spotting.
with a damp cloth or a sponge.
disinfectant. Do not use undiluted bleach. Do not
use alkaline detergents to clean plastic parts.
5
6
5
6
4