Care And Maintenance; Cleaning Your Beverage Center; Power Failure; Moving Your Beverage Center - Cavavin C-73WBVC Manuel D'instruction

Cleaning your beverage center

Turn off the power, unplug the appliance, and remove all items including shelves. Wash the inside
surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of
baking soda to 1 cup of water.
Wash the shelves with a mild detergent solution. Wring excess water out of the sponge or cloth when
cleaning area of the controls, or any electrical parts.
Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a
clean soft cloth. Do not use steel wool or steel brush on the stainless steel. These will contaminate the
stainless steel with steel particles and rusting may occur.

Power failure

Most power failures are corrected within a few hours and should not affect the temperature of your
appliance if you minimize the number of times the door is opened. If the power is going to be off for a
longer period of time, you need to take the proper steps to protect your contents.

Moving your beverage center

− Remove all items (bottles)
− Tape down securely all loose items (shelves) inside your appliance.
− Turn the adjustable leg up to the base to avoid damage.
− Tape the door shut.
− Be sure the appliance stays secure in the upright position during transportation. If you absolutely
need to transport the cellar horizontally, transport the cellar on its back (door on top). Also protect
outside of appliance with a blanket, or similar item.

Energy saving tips

The beverage center should be located in the coolest area of the room, away from heat producing
appliances, and out of the direct sunlight.

Charcoal Filtration system

Your wine is a living object that breathes through the cork of its bottle. In order to preserve the quality
and taste of your fine wines, they must be stored at the ideal temperature and ambient conditions.
Your cellar is equipped with an active charcoal filtration system to ensure air purity, cooling efficiency,
and to maintain an odor free cabinet for the storage of your fine wines. The filter assembly is located
at the rear panel inside your cellar. Keep in mind, that this filter must be changed every 12 months. To
replace your filter:
1 Remove the bottles / cans stored on the two (2) shelves in front of
the filter.
2 Remove the shelves and set aside to be replaced once you have
changed the filter
3 Hold the filter and turn it at 90 degrees in the anti-clockwise
direction and then pull it out.
4 Remove the existing filter and replace with a new one.
5 Put the new filter into the hole and then turn the filter at 90 degrees
in clockwise direction.
All manuals and user guides at all-guides.com

CARE AND MAINTENANCE

27