Philips Saeco HD 8525 Mode D'emploi page 26

13 Repeat the operations once again from step (8), for a total
of 4 tanks.
14 19 Remove the fi lter holder from the unit by turning it from
right to left and rinse it with fresh drinking water.
The descaling cycle is now complete.
2 Refi ll the tank with fresh water. If necessary, prime the
circuit as described in section 4.5.
At the end, press and hold the "
for 3 seconds; the " " light (15) turns off .
The descaling solution is to be disposed of ac-
cording to the manufacturer's instructions
and/or the regulations in force in the country of use.
13 "Intenza+" Filter (Optional)
The "INTENZA+" water fi lter can improve the quality of water.
Using the "INTENZA+" fi lter will prevent limescale from
building up and will ensure a much more intense aroma to
your espresso coff ee. We therefore recommend you install the
"INTENZA+" water fi lter, which can be purchased from your
local dealer or on-line at the Philips on-line store http://shop.
philips.com or at authorized service centres.
• 34 Remove the small white fi lter from the tank and store
it in a dry place sheltered from dust.
• 32 Remove the "INTENZA+" water fi lter from its package.
Set the fi lter according to the water hardness.
• 33 Immerse the "INTENZA+" water fi lter vertically in cold
water (with the opening positioned upwards) and gently
press its sides to let the air bubbles out.
• Put the fi lter into the empty tank. Press it until its limit
35
stop.
• Fill the water tank with fresh drinking water and reinsert it
into the machine.
Carry out the following steps to activate the "Intenza+"
fi lter:
• 4 Press the ON/OFF button (10). The " " light (14) starts
blinking. Wait until the " " light (14) turns on steady.
• 5 Place a container or a tea glass under the steam wand
(Pannarello).
• Open the knob (3) by turning it clockwise.
• 6 When about 1 litre of hot water has been dispensed,
close the knob (3) by turning it counter-clockwise.
• Empty the hot water container.
• 26 •
blinking: this is a normal behaviour of the machine.
Close the knob. Wait until the " " light (14) is steady on
before opening the knob again.
Now the fi lter is active and the machine is ready for use.
" (11) and " " (12) buttons
- The packing materials can be recycled.
- Appliance: unplug the appliance and cut the power cord.
- Deliver the appliance and power cord to a service center or
This product complies with eu directive 2002/96/EC.
The symbol
cates that this product may not be treated as household waste.
Instead it shall be handed over to the applicable collection
point for the recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment
and human health, which could otherwise be caused by inap-
propriate waste handling of this product. For more detailed in-
formation about recycling of this product, please contact your
local city offi ce, your household waste disposal service or the
shop where you purchased the product.
During this operation the pump is automati-
cally disengaged and the "
14 Disposal
public waste disposal facility.
on the product or on its packaging indi-
" light (16) is