Monacor International IMG STAGELINE TXS-420SX Guide Rapide page 2

TXS-420SX TXS-422SX
Order No. 24.0750 Order No. 24.0720
Pocket Transmitter with
GB
Headband Microphone
433.05 / 433.55 MHz
Please read these instructions carefully prior to set-
ting the unit into operation and keep them for later
use.
1 Applications
In combination with a receiver, the transmitter
TXS-4..SX makes up a wireless microphone
system. This system allows wireless transmission of
music and speech from the microphone to the re-
ceiver. The range is approx. 30 m and depends on
local conditions.
It is possible to combine e. g. the following trans-
mission systems from the "img Stage Line" range
with the TXS-4..SX transmitters:
suitable for
Type
TXS-420SX
TXS-400SET
1-channel system
TXS-440SET
2-channel system TXS-462SET
Active speaker
system with wireless TXA-400
microphone
1.1 Conformity and Approval
Herewith, MONACOR INTERNATIONAL declare
that the units TXS-420SX and TXS-422SX are
in accordance with the basic requirements and
the other relevant regulations of the directive
1995/5/EC. The declaration of conformity can be
found in the Internet via the MONACOR INTER-
NATIONAL home page (www.imgstageline.com).
The units are licence-free and generally approved
for operation in EU and EFTA countries.
2 Important Notes
The transmitter and the microphone are suitable
for indoor use only. Protect them against dripping
water and splash water, high air humidity and
heat (admissible ambient temperature range
0 – 40 °C).
1a
1c
1d
7
®
Copyright
For cleaning only use a dry, soft cloth, by no
means chemicals or water.
No guarantee claims for the transmitter or the
microphone and no liability for any resulting per-
sonal damage or material damage will be accept-
ed if the transmitter or the microphone is used for
other purposes than originally intended, if it is not
correctly operated or not repaired in an expert way.
If the transmitter and the microphone are to
be put out of operation definitively, take
them to a local recycling plant for a dispos-
al which is not harmful to the environment.
Dead batteries or defective rechargeable batteries
do not belong in the household rubbish, always
take them to a special waste disposal (e. g. collec-
tive container at your retailer).
3 Mounting the Headband
suitable for
Microphone
TXS-422SX
1) Widen or narrow the head piece according to
TXS-402SET
your head size (fig. 1a).
TXS-442SET
2) If necessary, modify the angle of the ear piece to
TXS-462SET obtain a comfortable fit (fig. 1b).
3) Adjust the strap on the head piece to ensure a
tight fit (fig. 1c).
—
4) Clamp the microphone and the cable holder to
the head piece (fig. 1d).
5) Put on the head piece and adjust the microphone
in such a way that it is max. 15 mm from the cor-
ner of your mouth (fig. 1e).
4 Setting into Operation
1) Open the battery compartment. Insert a 9 V bat-
tery with the positive and negative poles as indi-
cated in the battery compartment (fig. 3).
2) Fasten the transmitter on your belt by means of
the clip (3). If required, turn the clip by 90° (locks
into place). For this purpose, slightly release the
screw on the clip and then retighten it.
3) Connect the headband microphone to the jack
(5) on the transmitter. The microphone plug can
be secured from getting loose by screwing the
knurled nut [(7) in fig. 1d] of the plug on the jack.
© by MONACOR INTERNATIONAL GmbH & Co. KG, Bremen, Germany. All rights reserved.
4) Adjust the input sensitivity with the switch SENS
(6) in the batttery compartment:
pos. 1
pos. 2
pos. 3
5) Switch on the transmitter with the sliding switch
POWER (2). The red LED (1) lights up as a
power indicator. If it fails to light up or if it only
shows a dim light, the battery is exhausted and
must be replaced.
tion ON. In mid-position, the transmitter is mute,
i. e. it is switched on but no sound is transmitted.
6) Speak into the microphone. Advance the control
VOL (4) to such an extent that the receiver is not
overloaded, i. e. that the transmission signal is
not distorted.
7) Remember to switch off the transmitter after
operation. If it is not used for a longer period
(e. g. more than a week), the battery should be
removed to prevent any damage to the transmit-
ter caused by potential battery leakage.
5 Specifications
Carrier frequency
TXS-420SX: . . . . . . . . 433.05 MHz
TXS-422SX: . . . . . . . . 433.55 MHz
Transmitting power: . . . . . < 10 mW (EIRP)
Frequency stability: . . . . . ±0.005 %/25 °C,
Modulation: . . . . . . . . . . . FM, ±40 kHz
Audio frequency range: . . 50 – 15 000 Hz
Range: . . . . . . . . . . . . . . . approx. 30 m
Ambient temperature: . . . 0 – 40 °C
Power supply: . . . . . . . . . 9 V battery
Dimensions: . . . . . . . . . . . 66 x 110 x 35 mm
Weight: . . . . . . . . . . . . . . . 80 g
Subject to technical change.
1b
1e
for connecting an electric guitar or an-
other signal source with an output level
of 600 mV max.
for connecting a dynamic microphone
for the supplied headband microphone
or for another electret microphone or
capacitor microphone; there is an oper-
ating voltage of 5 V at the contact tip of
the microphone plug
Slide the switch POWER to the left stop to posi-
quartz-controlled
POWER VOL.
ON OFF
1 2 3 4 5
2
6
3
A-0667.99.02.10.2006
9V