Installation; Noises - Electrolux IK2070SR Notice D'utilisation

68 www.electrolux.com
7.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

8. INSTALLATION
8.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only be
guaranteed within the
specified temperature range.
If you have any doubts
regarding where to install the
appliance, please turn to the
vendor, to our customer
service or to the nearest
Authorised Service Centre.
8.2 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.

9. NOISES

There are some sounds during normal running (compressor, refrigerant circulation).
All manuals and user guides at all-guides.com
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the E.E.C.
Directives.
8.3 Ventilation requirements
The airflow behind the appliance must be
sufficient.
min.
5 cm
2
200 cm
CAUTION!
Refer to the assembly
instructions for the
installation.
min.
2
200 cm