Electrolux IK2070SR Notice D'utilisation page 67

All manuals and user guides at all-guides.com
Problem
Water flows on the floor.
Temperature cannot be set. The ActionFreeze or
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Possible cause
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
Shopping Function func-
tion is switched on.
The appliance is in dem-
onstration mode.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
The ActionFreeze function
is switched on.
The Shopping Function
function is switched on.
7.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
ENGLISH
Solution
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off ActionFreeze or
Shopping Function manually,
or wait until the function re-
sets automatically to set the
temperature. Refer to "Ac-
tionFreeze or Shopping Func-
tion function".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Refer to "ActionFreeze func-
tion".
Refer to "Shopping Function
function".
67