Operation; Connections And Control Devices; Overheating Protection - ESAB Aristo/Origo Mig 4002c Manuel D'instructions

GB
6

OPERATION

General safety regulations for the handling of the equipment can be found on
page 4. Read through before you start using the equipment!
WARNING!
Fasten the equipment - particularly if the
ground is uneven or sloping.
6.1

Connections and control devices

1
Mains supply switch
2
Indicating lamp, power supply ON
3
Indicating lamp, overheating / fault
4
Connection for welding current cable (+)
6.2

Overheating protection

The power source has one thermal overload trip which operates if the internal
temperature becomes too high, interrupting the welding current and lighting the
orange indicating lamp on the front of the unit. It resets automatically when the
temperature has fallen and the indicating lamp will go out.
mxx02cwe
5
Connection for welding current cable (--)
6
Control cable socket (from / to wire feeder)
7
Connection for welding current cable (+)
- - 11 - -