Assembly Of Counter Balance; Operation; Connection And Control Devices - ESAB Origo Mig 410 Manuel D'instructions

GB
5.4

Assembly of counter balance

Assemble the stabilizer + CB KIT if the counter balance is to be installed on machine.
The stabilizer + CB KIT is an accessory. Ordering number you can find on page 48.
Attention! Utilization of counter balance without stabilizer may cause the machine
tipping over.
6

OPERATION

General safety regulations for the handling of the equipment can be found on
page 4. Read through before you start using the equipment!
WARNING - - TIPPING RISK!
There is a risk of tipping while transportation and operation, if the welding machine leans
o
more than 10 . In that case appropriate securing has to be provided !
6.1

Connection and control devices

1
Mains supply switch
2
Switch, precise control
3
Switch, coarse control
4
Indicating lamp, power supply ON
5
Orange indicating lamp, overheating
6
Digital meter
mi410,510e
7
Connection for return cable (--), high induc-
tance
8
Connection for return cable (--), medium in-
ductance (Mig 510)
9
Connection for return cable (--), low induc-
tance
10
Connection for welding current cable (+)
11
Connection for control cable for wire feeder
12
MCB
- - 12 - -