Starting The Engine - Titan HYDRA X 4540 Mode D'emploi

OPERATION
12. Make sure the sprayer is grounded/earthed. All sprayers are
equipped with a grounding/earthing lug. A grounding/
earthing cable should be used to connect the sprayer to a
true earth ground. Check your local electrical regulations
for detailed grounding/earthing instructions.
Proper grounding/earthing is important. The
passage of some materials through the nylon
fluid hose will build up a static electric charge,
which if discharged, could ignite solvent vapors
present and create an explosion.
13. Strain all paints with a nylon strainer to ensure trouble
free operation and freedom from frequent cleaning of the
suction filter and gun filter.
14. Make sure the spray area is well ventilated to prevent
hazardous operation with volatile solvents or exhaust
fumes.
If lacquer or other flammable materials are to be
sprayed, ALWAYS locate the sprayer outside the
immediate spraying area. Failure to do so may
cause an explosion.
15. Locate the sprayer outside the immediate spraying area to
avoid clogged air intake of the engine with overspray.
14
4.2

STARTING THE ENGINE

Follow these instructions whenever prompted in
i
this manual to start the engine.
1. Move the fuel valve lever (Fig. 9, item 2) to the open
position.
2. Move the throttle lever (3) to its middle point.
3. Move the choke lever (4) to the closed position for a cold
engine or to the open position for a warm engine.
4. Turn the ignition key (1) to the ON position.
5. Pull the starter rope (5) briskly until the engine starts, or
turn the ignition key (1) all the way to the right until the
engine starts.
4
2
If choke lever (4) was moved to closed position to
i
start the engine, it must be opened again once
the engine is running.
HYDRA X
1
3
5