Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
P
ROBLEM
ENCOUNTERED
The device's surface
is very hot.
For devices equipped with a programming system or controlled via a pilot wire:
The device is not
responding to the
external program-
ming commands.
If you do not succeed in solving your problem, contact your local installer and have the
details of your device's references, the room's temperature and the programming system
(if any) to hand.
It is normal for the device to be hot when it is operating; the maximum sur-
face temperature is restricted in accordance with the NF electrical perfor-
mance standard. However, if you think that your device is still too hot, check
that the output is suitable for the area of your room (we recommend 100W /
m
2
) and that the heater is not placed in a draught, which would interfere with
its self-regulation; also check that the installation guidelines have been fol-
lowed (curtains, etc.)
Make sure that the central programming system is working correctly (refer
to the user manual), or that the programming control is correctly placed in
its holder and that it is working correctly (check the batteries, fuse, etc.)
Make sure that your device is in Programming mode and that the external
"Centralised" program is assigned to the right day of the week.
C
HECKS TO BE MADE
48
Publicité
Chapitres
Table des Matières
