Publicité
Les langues disponibles
Les langues disponibles
JCI1: Chassis Intrusion Connector
This connector allows you to connect the chassis intrusion switch cable.
Using chassis intrusion detector
1.
Connect the JCI1 connector to the chassis intrusion switch/ sensor on the chassis.
2.
Close the chassis cover.
3.
Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
4.
Set Chassis Intrusion to Enabled.
5.
Press F10 to save and exit and then press the Enter key to select Yes.
6.
Once the chassis cover is opened again, a warning message will be displayed on
screen when the computer is turned on.
Resetting the chassis intrusion warning
1.
Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
2.
Set Chassis Intrusion to Reset.
3.
Press F10 to save and exit and then press the Enter key to select Yes.
JLPT1: Parallel Port Connector
This connector allows you to connect the optional parallel port with bracket.
Normal
(default)
2
1
1
RSTB#
2
4
ERR#
5
7
PRND2
8
10
Ground
11
13
PRND5
14
16
Ground
17
19
ACK#
20
22
Ground
23
25
SLCT
26
Trigger the chassis
intrusion event
26
25
AFD#
3
PRND1
6
LPT_SLIN#
9
PRND4
12
Ground
15
PRND7
18
Ground
21
PE
24
No Pin
Overview of Components
PRND0
PINIT#
PRND3
Ground
PRND6
Ground
BUSY
Ground
19
Publicité
