Publicité
Les langues disponibles
Les langues disponibles
Failure to follow all of these instructions may result in death or serious injury
INDEX
A. BEFORE EACH TRIP
B. LUBRICATION
C. ASSEMBLY/ADJUSTMENT
D. HITCH INSTALLATION
E. HITCH REMOVAL
F. HITCH MATCHING GUIDE
BEFORE EACH TRIP:
1.
Lubricate skid plate surface of the hitch and pivot pin grease fitting (see Figure 1) with automotive type chassis grease.
Skid plate can also use a plastic lubrication plate to provide a lubricated surface. Use lithium grease to lubricate pivot
point of moving parts within the hitch. (see Figure 2, 3, and 4)
2.
Plastic lubrication plates (Towing Products No. 83001/40001) can be used to avoid messy grease. Other plastic
lubrication plate must not exceed 3/16 of an inch in thickness to ensure hitch will operate properly. Lubrication plates
must be 12 inches in diameter or larger to properly distribute king pin weight.
3.
Before each trip or hook up, operate the handle and check that the jaw opens and closes freely.
4.
See that all hitch pull pins (# 13, Figure 33) are in place and the retaining clips (#14, Figure 33) are installed (Figure 1).
Note that hitch pull pins used with the hitch are 90 degree bent pins and if replacements are needed, please contact
Cequent Performance Products. Check that all four anchor assembly handles are lynch pinned/locked through base
arch shell.
Site Holes (2)
Pivot Pin
Retaining
Clip
30160N – 2OCT14
FOR KIT 30160
P.2
P.3
P.4
P.8
P.8
P.9
Figure 1 : Pins and Clips (Skid Plate cut away view)
REV. B
2014 CEQUENT™ PERFORMANCE PRODUCTS, INC
WARNING:
G. HITCHING PROCEDURE
H. PULL TEST
I.
UNHITCHING PROCEDURE
J. MAINTENANCE
K. PARTS EXPLOSION
L. LIMITED LIFETIME WARRANTY
Lubricate Skid Plate
(or use plastic Lubrication Plate)
Lubricate Jaw
Lynch
Anchor Handles
To
prevent
detachment
separation of hitch you must
Pull Pin
make sure that the anchor
assemblies
installed and pinned, and
the
retaining
properly installed onto the
½" pull pins before towing.
The
retaining
easily be seen through the
site holes in the top of the
head.
Pins
PRINTED IN MEXICO
P.12
P.14
P.15
P.15
P.16
P.17
WARNING:
tilting
head
and
or
are
properly
clips
are
clips
can
2
Publicité
